Skylight / July 8, 2018 / Baptiste Allain
If the room you intend to illuminate with the skylight has an open ceiling with no attic space above you can install the skylight without needing to construct a light shaft. This is by far the simplest installation and it offers the maximum amount of light and a view of the sky. For ceilings with an attic space above a light shaft must be constructed that connects the skylight to the room. Skylight shafts take one of three forms: Straight in which the shaft drops vertically from the roof to the ceiling and is the same dimension as the skylight itself. This type is the easiest to construct but because of its offset angle relative to the skylight offers the least amount of light.
Solar heat control glazing - Manufacturers use various glazing methods to reduce the impact of summer time solar heat gains and winter time heat losses. These come in the form of heat-absorbing tints double and tripled paned skylights and low-emissivity coatings. Slope When your window professional installs your skylight one of the factors they will take into consideration is the slope. The slope or tilt of the skylight affects the amount of solar heat gain. A low slope on your skylight admits more solar heat in the summer and less in the winter which is the opposite of the effect you are trying to achieve As a rule of thumb you want to achieve a slope equal to your geographical latitude plus 5 to 15 degrees.
You will need to position and mark the opening on the ceiling after the skylight is installed. Take into consideration the size of the room and the amount of light you wish to bring in and select the size and position of the hole accordingly. Once the skylight is installed and the ceiling hole is cut its then a matter of connecting the two with the shaft which is typically constructed from 2x4 or 2x6 lumber. The angles involved typically require some tricky framing and is probably best left to an experienced carpenter. After the framing is completed the inside of the shaft is covered with wood or drywall and the attic side is insulated to minimize heat loss.