Skylight / July 11, 2018 / Nicolas Charlebois
This heat gain can be minimized by installing your south-facing skylight in the shade of deciduous trees or adding a moving window covering. Skylights come in all shapes and sizes. Its size greatly affects the illumination level and temperature of the space below. As a rule of thumb the size of a skylight should never be more than 5% of the floor area in rooms with many windows; and no more than 15% of the rooms total floor area for spaces with few windows. Dept. of Energy. Glazing Like windows skylight manufacturers use different types of glazing to improve their energy efficiency. The glazing comes in three different forms. Plastic glazing - This type of glazing is usually inexpensive and less likely to break than other glazing materials.
Solar heat control glazing - Manufacturers use various glazing methods to reduce the impact of summer time solar heat gains and winter time heat losses. These come in the form of heat-absorbing tints double and tripled paned skylights and low-emissivity coatings. Slope When your window professional installs your skylight one of the factors they will take into consideration is the slope. The slope or tilt of the skylight affects the amount of solar heat gain. A low slope on your skylight admits more solar heat in the summer and less in the winter which is the opposite of the effect you are trying to achieve As a rule of thumb you want to achieve a slope equal to your geographical latitude plus 5 to 15 degrees.
You will need to position and mark the opening on the ceiling after the skylight is installed. Take into consideration the size of the room and the amount of light you wish to bring in and select the size and position of the hole accordingly. Once the skylight is installed and the ceiling hole is cut its then a matter of connecting the two with the shaft which is typically constructed from 2x4 or 2x6 lumber. The angles involved typically require some tricky framing and is probably best left to an experienced carpenter. After the framing is completed the inside of the shaft is covered with wood or drywall and the attic side is insulated to minimize heat loss.