Skylight / July 9, 2018 / Delphine Demers
Solar heat control glazing - Manufacturers use various glazing methods to reduce the impact of summer time solar heat gains and winter time heat losses. These come in the form of heat-absorbing tints double and tripled paned skylights and low-emissivity coatings. Slope When your window professional installs your skylight one of the factors they will take into consideration is the slope. The slope or tilt of the skylight affects the amount of solar heat gain. A low slope on your skylight admits more solar heat in the summer and less in the winter which is the opposite of the effect you are trying to achieve As a rule of thumb you want to achieve a slope equal to your geographical latitude plus 5 to 15 degrees.
The structure of the house is another deciding factor. If there are beams pillars or pipes in the way the skylight on the roof may not get the right amount of visibility. Making structural changes is not an affordable option in most cases. So it is better to evaluate the room before you place skylights on the roof. In most cases skylights should be built into the house at the time of drawing the design of the house. In case skylights are introduced at a later point of time care must be taken to ensure that they are placed correctly and installed properly. Skylights are overhead windows often in a roof that allow sunlight to filter inside any enclosed area; they are a great natural light option to artificial lighting solutions during the daytime.
You will need to position and mark the opening on the ceiling after the skylight is installed. Take into consideration the size of the room and the amount of light you wish to bring in and select the size and position of the hole accordingly. Once the skylight is installed and the ceiling hole is cut its then a matter of connecting the two with the shaft which is typically constructed from 2x4 or 2x6 lumber. The angles involved typically require some tricky framing and is probably best left to an experienced carpenter. After the framing is completed the inside of the shaft is covered with wood or drywall and the attic side is insulated to minimize heat loss.