Skylight / October 18, 2018 / Arnou Gabriaux.
Fixed skylights are among the most popular and they come in a wide variety of shapes. Ventilated skylights can be opened and closed to allow the passage of air. These make a great addition to bathrooms and kitchens and they can be controlled by temperature sensor remote control wall switch and manual or motorized cranks. Tubular skylights are among the newest styles. They are popular because they are small and can be used where full-sized skylights will not fit. They allow for the passage of light and theyre installed the same way as regular skylights. Flat glass skylights are built into a framework (usually made of wood rubber or metal) and can be placed directly into a cut hole in your roof.
Angled where the shaft is parallel to the pitch of the skylight. It too is the same dimension as the skylight but its straight-in angle offers more light than a straight shaft. Angled shafts also are used to connect two locations that cannot otherwise be aligned. This occurs when the skylight must be installed in a particular spot - between two trusses for example - and the shaft opening is likewise limited to a particular location on the ceiling that is not directly under the skylight. Splayed or pyramid in which the ceiling opening is larger than the skylight opening in width length or both. This type although a little harder to construct is the most popular simply because it allows a smaller skylight to illuminate a larger area.
Solar heat control glazing - Manufacturers use various glazing methods to reduce the impact of summer time solar heat gains and winter time heat losses. These come in the form of heat-absorbing tints double and tripled paned skylights and low-emissivity coatings. Slope When your window professional installs your skylight one of the factors they will take into consideration is the slope. The slope or tilt of the skylight affects the amount of solar heat gain. A low slope on your skylight admits more solar heat in the summer and less in the winter which is the opposite of the effect you are trying to achieve As a rule of thumb you want to achieve a slope equal to your geographical latitude plus 5 to 15 degrees.
For example the optimum slope for a south-facing skylight in Columbus Ohio at 40º North latitude is 45º to 55º. Every skylight has a "shaft" which governs how much light is admitted into the room below. If all four sides are flared then the light is spread over a wide area. If your skylight has a shaft with perpendicular sides the light is focused straight below. If your skylights shaft is flared on only one or two sides then the light is sprayed in the flared direction. Ventilation If you wish you can have a skylight which also provides ventilation as well as light to your room. This allows you to release the hot air which collects at your ceiling.