Skylight / July 12, 2018 / Odo Vaillancour
However these surfaces scratch easily and can become brittle and discolored. Glass glazing - This is found in the more expensive skylights. It is more durable than plastic and does not discolor. All glass used for skylights must be made of "safety glazing" a generic term for both tempered and laminated glass. Tempered glass is the most impact resistant. Laminated glass is fabricated with a thin layer of plastic embedded near the center of the glass. Both types keep the glass from breaking into large sharp pieces. Skylights are often made with a tempered glass on the exterior side and a laminated pane on the interior side. This arrangement gives maximum impact resistance while protecting occupants from falling shards of glass.
Solar heat control glazing - Manufacturers use various glazing methods to reduce the impact of summer time solar heat gains and winter time heat losses. These come in the form of heat-absorbing tints double and tripled paned skylights and low-emissivity coatings. Slope When your window professional installs your skylight one of the factors they will take into consideration is the slope. The slope or tilt of the skylight affects the amount of solar heat gain. A low slope on your skylight admits more solar heat in the summer and less in the winter which is the opposite of the effect you are trying to achieve As a rule of thumb you want to achieve a slope equal to your geographical latitude plus 5 to 15 degrees.
You will need to position and mark the opening on the ceiling after the skylight is installed. Take into consideration the size of the room and the amount of light you wish to bring in and select the size and position of the hole accordingly. Once the skylight is installed and the ceiling hole is cut its then a matter of connecting the two with the shaft which is typically constructed from 2x4 or 2x6 lumber. The angles involved typically require some tricky framing and is probably best left to an experienced carpenter. After the framing is completed the inside of the shaft is covered with wood or drywall and the attic side is insulated to minimize heat loss.