Skylight / July 11, 2018 / Nicolas Charlebois
However these surfaces scratch easily and can become brittle and discolored. Glass glazing - This is found in the more expensive skylights. It is more durable than plastic and does not discolor. All glass used for skylights must be made of "safety glazing" a generic term for both tempered and laminated glass. Tempered glass is the most impact resistant. Laminated glass is fabricated with a thin layer of plastic embedded near the center of the glass. Both types keep the glass from breaking into large sharp pieces. Skylights are often made with a tempered glass on the exterior side and a laminated pane on the interior side. This arrangement gives maximum impact resistance while protecting occupants from falling shards of glass.
Skylights are best suited to catch sunlight from the overhanging clouds. In addition to this skylight windows allow a deeper penetration of the suns light into the structure of the house in such a way that it is less obtrusive. Skylights also keep heating and cooling costs down. Skylights are your windows to the heaven. They can breathe drama into any living space. And they are all the rage these days. In such a scenario it is easy for people to forget important considerations while choosing skylights. Energy problems that influence windows operate just as strongly or even more so in skylights. For instance heat loss heat gains solar gains ventilation and water pooling affect skylight windows too.
You will need to position and mark the opening on the ceiling after the skylight is installed. Take into consideration the size of the room and the amount of light you wish to bring in and select the size and position of the hole accordingly. Once the skylight is installed and the ceiling hole is cut its then a matter of connecting the two with the shaft which is typically constructed from 2x4 or 2x6 lumber. The angles involved typically require some tricky framing and is probably best left to an experienced carpenter. After the framing is completed the inside of the shaft is covered with wood or drywall and the attic side is insulated to minimize heat loss.