Skylight / July 11, 2018 / Nicolas Charlebois
Angled where the shaft is parallel to the pitch of the skylight. It too is the same dimension as the skylight but its straight-in angle offers more light than a straight shaft. Angled shafts also are used to connect two locations that cannot otherwise be aligned. This occurs when the skylight must be installed in a particular spot - between two trusses for example - and the shaft opening is likewise limited to a particular location on the ceiling that is not directly under the skylight. Splayed or pyramid in which the ceiling opening is larger than the skylight opening in width length or both. This type although a little harder to construct is the most popular simply because it allows a smaller skylight to illuminate a larger area.
You will need to position and mark the opening on the ceiling after the skylight is installed. Take into consideration the size of the room and the amount of light you wish to bring in and select the size and position of the hole accordingly. Once the skylight is installed and the ceiling hole is cut its then a matter of connecting the two with the shaft which is typically constructed from 2x4 or 2x6 lumber. The angles involved typically require some tricky framing and is probably best left to an experienced carpenter. After the framing is completed the inside of the shaft is covered with wood or drywall and the attic side is insulated to minimize heat loss.
Your ventilating skylight can be operated by one of three ways: Manual skylight controls - These are opened by your use of an extended rod to manually crank the skylight open. These are designed for ceilings of less than 15 feet. Electronic skylight controls - A simpler model of this type of control is wired to a wall mounted switch which opens and closes the skylight. More complex models are controlled by a special wall console of a wireless remote control. Automatic operating controls - With this type of control integrated heat sensors trigger the skylight to open when the interior heat reaches a preset temperature. Exterior sensors automatically close the unit when they sense moisture.