Skylight / July 11, 2018 / Nicolas Charlebois
If the room you intend to illuminate with the skylight has an open ceiling with no attic space above you can install the skylight without needing to construct a light shaft. This is by far the simplest installation and it offers the maximum amount of light and a view of the sky. For ceilings with an attic space above a light shaft must be constructed that connects the skylight to the room. Skylight shafts take one of three forms: Straight in which the shaft drops vertically from the roof to the ceiling and is the same dimension as the skylight itself. This type is the easiest to construct but because of its offset angle relative to the skylight offers the least amount of light.
Skylights are best suited to catch sunlight from the overhanging clouds. In addition to this skylight windows allow a deeper penetration of the suns light into the structure of the house in such a way that it is less obtrusive. Skylights also keep heating and cooling costs down. Skylights are your windows to the heaven. They can breathe drama into any living space. And they are all the rage these days. In such a scenario it is easy for people to forget important considerations while choosing skylights. Energy problems that influence windows operate just as strongly or even more so in skylights. For instance heat loss heat gains solar gains ventilation and water pooling affect skylight windows too.
However these surfaces scratch easily and can become brittle and discolored. Glass glazing - This is found in the more expensive skylights. It is more durable than plastic and does not discolor. All glass used for skylights must be made of "safety glazing" a generic term for both tempered and laminated glass. Tempered glass is the most impact resistant. Laminated glass is fabricated with a thin layer of plastic embedded near the center of the glass. Both types keep the glass from breaking into large sharp pieces. Skylights are often made with a tempered glass on the exterior side and a laminated pane on the interior side. This arrangement gives maximum impact resistance while protecting occupants from falling shards of glass.