Skylight / July 11, 2018 / Nicolas Charlebois
The air near the ceiling is automatically cooled when fresh air flows in from outside. These roof skylights are so designed that they open and close a little to let in the fresh air. The glass tilts at about 45 degrees. There is a small handle to manually open the venting roof skylight. You crank the handle slightly to open or close or adjust the angle and position of the glass. The venting roof skylights are located in the ceiling of the house and are hard to reach so there is an extension to the handle. Otherwise every time you want to open or shut the venting roof skylight you will need a ladder or a high stool. Nowadays electronically operated venting skylights are also becoming very popular.
If the room you intend to illuminate with the skylight has an open ceiling with no attic space above you can install the skylight without needing to construct a light shaft. This is by far the simplest installation and it offers the maximum amount of light and a view of the sky. For ceilings with an attic space above a light shaft must be constructed that connects the skylight to the room. Skylight shafts take one of three forms: Straight in which the shaft drops vertically from the roof to the ceiling and is the same dimension as the skylight itself. This type is the easiest to construct but because of its offset angle relative to the skylight offers the least amount of light.
Fixed skylights are among the most popular and they come in a wide variety of shapes. Ventilated skylights can be opened and closed to allow the passage of air. These make a great addition to bathrooms and kitchens and they can be controlled by temperature sensor remote control wall switch and manual or motorized cranks. Tubular skylights are among the newest styles. They are popular because they are small and can be used where full-sized skylights will not fit. They allow for the passage of light and theyre installed the same way as regular skylights. Flat glass skylights are built into a framework (usually made of wood rubber or metal) and can be placed directly into a cut hole in your roof.