Skylight / November 15, 2018 / Odo Vaillancour.
There must be a clear opening in the area where the skylight is to be placed. A skylight that faces the East lets in plenty of morning sunshine while one that faces the West brings lets in the afternoon sunshine. It is important to know the amount of light and the type of light your skylight lets in. Afternoon sunlight can become uncomfortably hot if you live in a warm and dry place. The size of the room also has a bearing on the effectiveness of the skylight on your roof. If the room is small your choices are severely limited as skylights are best suited for large rooms. If you still want a skylight for a small room it is best to opt for an elegant pyramid skylight. This gives the illusion of space.
The air near the ceiling is automatically cooled when fresh air flows in from outside. These roof skylights are so designed that they open and close a little to let in the fresh air. The glass tilts at about 45 degrees. There is a small handle to manually open the venting roof skylight. You crank the handle slightly to open or close or adjust the angle and position of the glass. The venting roof skylights are located in the ceiling of the house and are hard to reach so there is an extension to the handle. Otherwise every time you want to open or shut the venting roof skylight you will need a ladder or a high stool. Nowadays electronically operated venting skylights are also becoming very popular.
Fixed skylights are among the most popular and they come in a wide variety of shapes. Ventilated skylights can be opened and closed to allow the passage of air. These make a great addition to bathrooms and kitchens and they can be controlled by temperature sensor remote control wall switch and manual or motorized cranks. Tubular skylights are among the newest styles. They are popular because they are small and can be used where full-sized skylights will not fit. They allow for the passage of light and theyre installed the same way as regular skylights. Flat glass skylights are built into a framework (usually made of wood rubber or metal) and can be placed directly into a cut hole in your roof.
The acrylic dome is typically mounted in an aluminum frame which is in turn mounted on a box called a "curb." Once the hole is cut in the roof to the manufacturers specifications the curb is typically constructed on-site to raise the skylight above the level of the roof sheathing. Site-built or factory-supplied flashings are used to seal the roofing around the curb. Domed skylights are available in clear smoked bronze or other tints. Some domed plastic skylights are flush mounted which means that the lens piece and flashing piece are both made of plastic and then placed on the roof without a curb. The problem with this type is that they are loud and very susceptible to leakage.