Skylight / July 12, 2018 / Odo Vaillancour
Angled where the shaft is parallel to the pitch of the skylight. It too is the same dimension as the skylight but its straight-in angle offers more light than a straight shaft. Angled shafts also are used to connect two locations that cannot otherwise be aligned. This occurs when the skylight must be installed in a particular spot - between two trusses for example - and the shaft opening is likewise limited to a particular location on the ceiling that is not directly under the skylight. Splayed or pyramid in which the ceiling opening is larger than the skylight opening in width length or both. This type although a little harder to construct is the most popular simply because it allows a smaller skylight to illuminate a larger area.
Your ventilating skylight can be operated by one of three ways: Manual skylight controls - These are opened by your use of an extended rod to manually crank the skylight open. These are designed for ceilings of less than 15 feet. Electronic skylight controls - A simpler model of this type of control is wired to a wall mounted switch which opens and closes the skylight. More complex models are controlled by a special wall console of a wireless remote control. Automatic operating controls - With this type of control integrated heat sensors trigger the skylight to open when the interior heat reaches a preset temperature. Exterior sensors automatically close the unit when they sense moisture.
However these surfaces scratch easily and can become brittle and discolored. Glass glazing - This is found in the more expensive skylights. It is more durable than plastic and does not discolor. All glass used for skylights must be made of "safety glazing" a generic term for both tempered and laminated glass. Tempered glass is the most impact resistant. Laminated glass is fabricated with a thin layer of plastic embedded near the center of the glass. Both types keep the glass from breaking into large sharp pieces. Skylights are often made with a tempered glass on the exterior side and a laminated pane on the interior side. This arrangement gives maximum impact resistance while protecting occupants from falling shards of glass.