Skylight / July 8, 2018 / Baptiste Allain
You will need to position and mark the opening on the ceiling after the skylight is installed. Take into consideration the size of the room and the amount of light you wish to bring in and select the size and position of the hole accordingly. Once the skylight is installed and the ceiling hole is cut its then a matter of connecting the two with the shaft which is typically constructed from 2x4 or 2x6 lumber. The angles involved typically require some tricky framing and is probably best left to an experienced carpenter. After the framing is completed the inside of the shaft is covered with wood or drywall and the attic side is insulated to minimize heat loss.
For instance flat roofs are more susceptible to drainage problems. Flat skylights on flat roofs may lead to water pooling. That is why experts recommend the use of domed skylights on flat roofs. This promotes drainage. Skylights for low pitch installation generally have significant slope built into the design. Attention must be paid to such things before installing skylights. Skylights are introduced into the design and architecture of the home to bring in lots of light heat and warmth. But what happens if there is a tall tree towering over the skylight on the roof? The very purpose of the skylight is defeated. The position of the skylight on the roof plays a vital role in determining its usefulness and effectiveness.
Your ventilating skylight can be operated by one of three ways: Manual skylight controls - These are opened by your use of an extended rod to manually crank the skylight open. These are designed for ceilings of less than 15 feet. Electronic skylight controls - A simpler model of this type of control is wired to a wall mounted switch which opens and closes the skylight. More complex models are controlled by a special wall console of a wireless remote control. Automatic operating controls - With this type of control integrated heat sensors trigger the skylight to open when the interior heat reaches a preset temperature. Exterior sensors automatically close the unit when they sense moisture.