Skylight / July 11, 2018 / Nicolas Charlebois
The shape of the skylights installed in your home will impact the design and look of the room. In the past skylights were prone to vapor build-up during the cold season. This vapor would then trickle down as water droplets into the room. However these days it is possible to buy skylights with channels that collect water vapor. More expensive skylights are less vulnerable to condensation related problems. Material: The kind of material used on skylights at home has a direct impact on their look and efficiency. Glass and plastic are the most popular materials used for glazing the skylights. Plastic skylights are less expensive and do not break easily. However plastic glazing may become discolored over time and may even have scratches. Glass on the other hand is scratch proof and does not fade. But it is more expensive and is usually found in commercial structures.
There must be a clear opening in the area where the skylight is to be placed. A skylight that faces the East lets in plenty of morning sunshine while one that faces the West brings lets in the afternoon sunshine. It is important to know the amount of light and the type of light your skylight lets in. Afternoon sunlight can become uncomfortably hot if you live in a warm and dry place. The size of the room also has a bearing on the effectiveness of the skylight on your roof. If the room is small your choices are severely limited as skylights are best suited for large rooms. If you still want a skylight for a small room it is best to opt for an elegant pyramid skylight. This gives the illusion of space.
You will need to position and mark the opening on the ceiling after the skylight is installed. Take into consideration the size of the room and the amount of light you wish to bring in and select the size and position of the hole accordingly. Once the skylight is installed and the ceiling hole is cut its then a matter of connecting the two with the shaft which is typically constructed from 2x4 or 2x6 lumber. The angles involved typically require some tricky framing and is probably best left to an experienced carpenter. After the framing is completed the inside of the shaft is covered with wood or drywall and the attic side is insulated to minimize heat loss.