Skylight / July 8, 2018 / Baptiste Allain
When these are pulled away and removed the drenched and water damaged roof beams come into view. Moisture comes from both inside and outside. Weather isnt the only thing that causes skylights to leak. Warm air from inside the house can catch in the skylight as it rises on warm air and then drips down onto furniture and valuables below. Modern skylight replacements can come with what is called low-e glass. This low emissivity glass keeps energy meant to heat or cool a room in and helps to reflect heat and cold out and away from the light itself. This is usually done through a special film that the glass is coated with. This film can block out UV rays and comes in many different filtering shades.
The structure of the house is another deciding factor. If there are beams pillars or pipes in the way the skylight on the roof may not get the right amount of visibility. Making structural changes is not an affordable option in most cases. So it is better to evaluate the room before you place skylights on the roof. In most cases skylights should be built into the house at the time of drawing the design of the house. In case skylights are introduced at a later point of time care must be taken to ensure that they are placed correctly and installed properly. Skylights are overhead windows often in a roof that allow sunlight to filter inside any enclosed area; they are a great natural light option to artificial lighting solutions during the daytime.
You will need to position and mark the opening on the ceiling after the skylight is installed. Take into consideration the size of the room and the amount of light you wish to bring in and select the size and position of the hole accordingly. Once the skylight is installed and the ceiling hole is cut its then a matter of connecting the two with the shaft which is typically constructed from 2x4 or 2x6 lumber. The angles involved typically require some tricky framing and is probably best left to an experienced carpenter. After the framing is completed the inside of the shaft is covered with wood or drywall and the attic side is insulated to minimize heat loss.