Skylight / July 8, 2018 / Baptiste Allain
You will need to position and mark the opening on the ceiling after the skylight is installed. Take into consideration the size of the room and the amount of light you wish to bring in and select the size and position of the hole accordingly. Once the skylight is installed and the ceiling hole is cut its then a matter of connecting the two with the shaft which is typically constructed from 2x4 or 2x6 lumber. The angles involved typically require some tricky framing and is probably best left to an experienced carpenter. After the framing is completed the inside of the shaft is covered with wood or drywall and the attic side is insulated to minimize heat loss.
Angled where the shaft is parallel to the pitch of the skylight. It too is the same dimension as the skylight but its straight-in angle offers more light than a straight shaft. Angled shafts also are used to connect two locations that cannot otherwise be aligned. This occurs when the skylight must be installed in a particular spot - between two trusses for example - and the shaft opening is likewise limited to a particular location on the ceiling that is not directly under the skylight. Splayed or pyramid in which the ceiling opening is larger than the skylight opening in width length or both. This type although a little harder to construct is the most popular simply because it allows a smaller skylight to illuminate a larger area.
Skylight windows are a wonderful addition to a home. Theres no doubt about it. But a lot depends on where exactly the house is located. Skylight windows are best suited for cool climates where the rays of the sun are not very harsh. Fortunately many places in the US have just this kind of weather. When used in such places skylight windows become the most important source of solar heating. And even when the sun is wobbly and there is little sunshine entering the room large skylight windows make the room look airy and bright dispelling the gloom. In areas where there is limited light and heat vertical windows are less efficient than large skylights because vertical sunlight is scant.