Skylight / July 14, 2018 / Onfroi Berger
To make sure that glass skylights are protected these are made of tempered glass on the outside and have a laminated pane on the inside. Position: Where and how you place skylights within the home is equally important. Location plays a vital role in natural lighting and solar heating. When they are placed on the roof and facing the north you can expect consistent but cool lighting. Skylights that face the east provide maximum solar energy in the mornings while those facing the west will give maximum afternoon sunlight. If heat is a problem you may install skylights in the shade of a tree or have a shading device on top of the skylight. The slope at which skylights are placed also controls the amount of heat and light received. Before buying skylights for the home do a little research. Prices tend to vary from a few hundred to a few thousand dollars. Price climbs with the addition of features like shading devices remote control and special glazing.
You will need to position and mark the opening on the ceiling after the skylight is installed. Take into consideration the size of the room and the amount of light you wish to bring in and select the size and position of the hole accordingly. Once the skylight is installed and the ceiling hole is cut its then a matter of connecting the two with the shaft which is typically constructed from 2x4 or 2x6 lumber. The angles involved typically require some tricky framing and is probably best left to an experienced carpenter. After the framing is completed the inside of the shaft is covered with wood or drywall and the attic side is insulated to minimize heat loss.
Angled where the shaft is parallel to the pitch of the skylight. It too is the same dimension as the skylight but its straight-in angle offers more light than a straight shaft. Angled shafts also are used to connect two locations that cannot otherwise be aligned. This occurs when the skylight must be installed in a particular spot - between two trusses for example - and the shaft opening is likewise limited to a particular location on the ceiling that is not directly under the skylight. Splayed or pyramid in which the ceiling opening is larger than the skylight opening in width length or both. This type although a little harder to construct is the most popular simply because it allows a smaller skylight to illuminate a larger area.