Skylight / July 12, 2018 / Odo Vaillancour
Typically flat glass skylights include all the installation materials and they are among the easiest to install. Moreover because they are glass these flat skylights are less likely to scratch. Domed acrylic skylights are among the most affordable especially compared to glass alternatives. These skylights are available in a variety of tints making them an attractive addition to any home or room. Unfortunately domed acrylic skylights do not offer the same noise protection as glass varieties and they tend to be more susceptible to leaking. Function Now that you know a little bit about the types of skylights available you should take some time to consider their function.
However these surfaces scratch easily and can become brittle and discolored. Glass glazing - This is found in the more expensive skylights. It is more durable than plastic and does not discolor. All glass used for skylights must be made of "safety glazing" a generic term for both tempered and laminated glass. Tempered glass is the most impact resistant. Laminated glass is fabricated with a thin layer of plastic embedded near the center of the glass. Both types keep the glass from breaking into large sharp pieces. Skylights are often made with a tempered glass on the exterior side and a laminated pane on the interior side. This arrangement gives maximum impact resistance while protecting occupants from falling shards of glass.
You will need to position and mark the opening on the ceiling after the skylight is installed. Take into consideration the size of the room and the amount of light you wish to bring in and select the size and position of the hole accordingly. Once the skylight is installed and the ceiling hole is cut its then a matter of connecting the two with the shaft which is typically constructed from 2x4 or 2x6 lumber. The angles involved typically require some tricky framing and is probably best left to an experienced carpenter. After the framing is completed the inside of the shaft is covered with wood or drywall and the attic side is insulated to minimize heat loss.