Skylight / July 15, 2018 / Arnou Gabriaux
The structure of the house is another deciding factor. If there are beams pillars or pipes in the way the skylight on the roof may not get the right amount of visibility. Making structural changes is not an affordable option in most cases. So it is better to evaluate the room before you place skylights on the roof. In most cases skylights should be built into the house at the time of drawing the design of the house. In case skylights are introduced at a later point of time care must be taken to ensure that they are placed correctly and installed properly. Skylights are overhead windows often in a roof that allow sunlight to filter inside any enclosed area; they are a great natural light option to artificial lighting solutions during the daytime.
If the room you intend to illuminate with the skylight has an open ceiling with no attic space above you can install the skylight without needing to construct a light shaft. This is by far the simplest installation and it offers the maximum amount of light and a view of the sky. For ceilings with an attic space above a light shaft must be constructed that connects the skylight to the room. Skylight shafts take one of three forms: Straight in which the shaft drops vertically from the roof to the ceiling and is the same dimension as the skylight itself. This type is the easiest to construct but because of its offset angle relative to the skylight offers the least amount of light.
However these surfaces scratch easily and can become brittle and discolored. Glass glazing - This is found in the more expensive skylights. It is more durable than plastic and does not discolor. All glass used for skylights must be made of "safety glazing" a generic term for both tempered and laminated glass. Tempered glass is the most impact resistant. Laminated glass is fabricated with a thin layer of plastic embedded near the center of the glass. Both types keep the glass from breaking into large sharp pieces. Skylights are often made with a tempered glass on the exterior side and a laminated pane on the interior side. This arrangement gives maximum impact resistance while protecting occupants from falling shards of glass.