Roof Windows / August 1, 2018 / Nicolas Charlebois
For example the optimum slope for a south-facing skylight in Columbus Ohio at 40º North latitude is 45º to 55º. Every skylight has a "shaft" which governs how much light is admitted into the room below. If all four sides are flared then the light is spread over a wide area. If your skylight has a shaft with perpendicular sides the light is focused straight below. If your skylights shaft is flared on only one or two sides then the light is sprayed in the flared direction. Ventilation If you wish you can have a skylight which also provides ventilation as well as light to your room. This allows you to release the hot air which collects at your ceiling.
However these surfaces scratch easily and can become brittle and discolored. Glass glazing - This is found in the more expensive skylights. It is more durable than plastic and does not discolor. All glass used for skylights must be made of "safety glazing" a generic term for both tempered and laminated glass. Tempered glass is the most impact resistant. Laminated glass is fabricated with a thin layer of plastic embedded near the center of the glass. Both types keep the glass from breaking into large sharp pieces. Skylights are often made with a tempered glass on the exterior side and a laminated pane on the interior side. This arrangement gives maximum impact resistance while protecting occupants from falling shards of glass.
Your ventilating skylight can be operated by one of three ways: Manual skylight controls - These are opened by your use of an extended rod to manually crank the skylight open. These are designed for ceilings of less than 15 feet. Electronic skylight controls - A simpler model of this type of control is wired to a wall mounted switch which opens and closes the skylight. More complex models are controlled by a special wall console of a wireless remote control. Automatic operating controls - With this type of control integrated heat sensors trigger the skylight to open when the interior heat reaches a preset temperature. Exterior sensors automatically close the unit when they sense moisture.