Skylight / November 12, 2018 / Baptiste Allain.
The acrylic dome is typically mounted in an aluminum frame which is in turn mounted on a box called a "curb." Once the hole is cut in the roof to the manufacturers specifications the curb is typically constructed on-site to raise the skylight above the level of the roof sheathing. Site-built or factory-supplied flashings are used to seal the roofing around the curb. Domed skylights are available in clear smoked bronze or other tints. Some domed plastic skylights are flush mounted which means that the lens piece and flashing piece are both made of plastic and then placed on the roof without a curb. The problem with this type is that they are loud and very susceptible to leakage.
When these are pulled away and removed the drenched and water damaged roof beams come into view. Moisture comes from both inside and outside. Weather isnt the only thing that causes skylights to leak. Warm air from inside the house can catch in the skylight as it rises on warm air and then drips down onto furniture and valuables below. Modern skylight replacements can come with what is called low-e glass. This low emissivity glass keeps energy meant to heat or cool a room in and helps to reflect heat and cold out and away from the light itself. This is usually done through a special film that the glass is coated with. This film can block out UV rays and comes in many different filtering shades.
Some people in an effort to let in plenty of light choose the biggest skylight they can afford. But bigger is not always better when it comes to choosing skylights for your home. The size of the skylight should not be more than 5% of the floor space if there are other windows in the room. It should be less than 15% of the floor space if there are few windows in the room. Unlike commercial buildings where structures are huge there is only so much that a room within the house can take. So choose skylights that suit the size of the room. Style: Although most skylights are rectangular these are available in a variety of sizes shapes and colors.
You will need to position and mark the opening on the ceiling after the skylight is installed. Take into consideration the size of the room and the amount of light you wish to bring in and select the size and position of the hole accordingly. Once the skylight is installed and the ceiling hole is cut its then a matter of connecting the two with the shaft which is typically constructed from 2x4 or 2x6 lumber. The angles involved typically require some tricky framing and is probably best left to an experienced carpenter. After the framing is completed the inside of the shaft is covered with wood or drywall and the attic side is insulated to minimize heat loss.