Skylight / July 16, 2018 / Delphine Demers
However these surfaces scratch easily and can become brittle and discolored. Glass glazing - This is found in the more expensive skylights. It is more durable than plastic and does not discolor. All glass used for skylights must be made of "safety glazing" a generic term for both tempered and laminated glass. Tempered glass is the most impact resistant. Laminated glass is fabricated with a thin layer of plastic embedded near the center of the glass. Both types keep the glass from breaking into large sharp pieces. Skylights are often made with a tempered glass on the exterior side and a laminated pane on the interior side. This arrangement gives maximum impact resistance while protecting occupants from falling shards of glass.
Your ventilating skylight can be operated by one of three ways: Manual skylight controls - These are opened by your use of an extended rod to manually crank the skylight open. These are designed for ceilings of less than 15 feet. Electronic skylight controls - A simpler model of this type of control is wired to a wall mounted switch which opens and closes the skylight. More complex models are controlled by a special wall console of a wireless remote control. Automatic operating controls - With this type of control integrated heat sensors trigger the skylight to open when the interior heat reaches a preset temperature. Exterior sensors automatically close the unit when they sense moisture.
Solar heat control glazing - Manufacturers use various glazing methods to reduce the impact of summer time solar heat gains and winter time heat losses. These come in the form of heat-absorbing tints double and tripled paned skylights and low-emissivity coatings. Slope When your window professional installs your skylight one of the factors they will take into consideration is the slope. The slope or tilt of the skylight affects the amount of solar heat gain. A low slope on your skylight admits more solar heat in the summer and less in the winter which is the opposite of the effect you are trying to achieve As a rule of thumb you want to achieve a slope equal to your geographical latitude plus 5 to 15 degrees.