Skylight / November 9, 2018 / Delphine Demers.
This is ideal for cubicles or small offices even restrooms. The places where tubular skylights are most effective are in the bottom floor of a multi-story building in order to light the space with natural sunlight warehouses private offices or to prevent heat loss and for solar gain. The installation of tubular skylights requires a professional installer who can work with the thickness of your ceiling and angles to get the most out of your skylight. The top panel of the skylight will be affixed to your roof with the channel running through the ceiling completely hidden from sight with the bottom window attached on the visible area of the ceiling.
Another modern option is to have a replacement skylight with double panes of glass with a layer of argon gas infused in between the panes. New features and options make getting a replacement skylight a more viable option than just shingling over the old one. Remote controls make it possible to open and close a skylight on a whim rather than having to clamber about on ladders. Some skylights can also come with rain sensors so they will close the moment they feel raindrops or too much moisture. These options allow the skylight to vent the house while also protecting it against damage.
For example the optimum slope for a south-facing skylight in Columbus Ohio at 40º North latitude is 45º to 55º. Every skylight has a "shaft" which governs how much light is admitted into the room below. If all four sides are flared then the light is spread over a wide area. If your skylight has a shaft with perpendicular sides the light is focused straight below. If your skylights shaft is flared on only one or two sides then the light is sprayed in the flared direction. Ventilation If you wish you can have a skylight which also provides ventilation as well as light to your room. This allows you to release the hot air which collects at your ceiling.
You will need to position and mark the opening on the ceiling after the skylight is installed. Take into consideration the size of the room and the amount of light you wish to bring in and select the size and position of the hole accordingly. Once the skylight is installed and the ceiling hole is cut its then a matter of connecting the two with the shaft which is typically constructed from 2x4 or 2x6 lumber. The angles involved typically require some tricky framing and is probably best left to an experienced carpenter. After the framing is completed the inside of the shaft is covered with wood or drywall and the attic side is insulated to minimize heat loss.