Skylight / July 15, 2018 / Arnou Gabriaux
After the hole is cut the skylight frame is simply attached to the roof sheathing with L-brackets and then the installation is completed using the factory-supplied flashing kit. Ease of installation superior insulating qualities less tendency to scratch and a cleaner finished appearance all add to the popularity and somewhat higher cost of glass skylights. Glass skylights also have a greater number of optional accessories. These include tempered laminated or wire glass; shades and blinds for light control; glass tints for heat retention or to block sunlight; and the ability to open fully or partially for ventilation. Domed acrylic skylights are less expensive than glass.
If the room you intend to illuminate with the skylight has an open ceiling with no attic space above you can install the skylight without needing to construct a light shaft. This is by far the simplest installation and it offers the maximum amount of light and a view of the sky. For ceilings with an attic space above a light shaft must be constructed that connects the skylight to the room. Skylight shafts take one of three forms: Straight in which the shaft drops vertically from the roof to the ceiling and is the same dimension as the skylight itself. This type is the easiest to construct but because of its offset angle relative to the skylight offers the least amount of light.
Fixed skylights are among the most popular and they come in a wide variety of shapes. Ventilated skylights can be opened and closed to allow the passage of air. These make a great addition to bathrooms and kitchens and they can be controlled by temperature sensor remote control wall switch and manual or motorized cranks. Tubular skylights are among the newest styles. They are popular because they are small and can be used where full-sized skylights will not fit. They allow for the passage of light and theyre installed the same way as regular skylights. Flat glass skylights are built into a framework (usually made of wood rubber or metal) and can be placed directly into a cut hole in your roof.