Skylight / July 16, 2018 / Baptiste Allain
However these surfaces scratch easily and can become brittle and discolored. Glass glazing - This is found in the more expensive skylights. It is more durable than plastic and does not discolor. All glass used for skylights must be made of "safety glazing" a generic term for both tempered and laminated glass. Tempered glass is the most impact resistant. Laminated glass is fabricated with a thin layer of plastic embedded near the center of the glass. Both types keep the glass from breaking into large sharp pieces. Skylights are often made with a tempered glass on the exterior side and a laminated pane on the interior side. This arrangement gives maximum impact resistance while protecting occupants from falling shards of glass.
It will also make all the difference for a skylight that doesnt have newer methods for moving condensation away from the window. It is possible that some skylights are suffering manufacturer related defects. Most worthy manufacturers of skylights or replacements will guarantee their product. A new and complete skylight will be sent and installed hopefully at no cost. It will require the same installation techniques as applied with the first but will obviously be better all around. It is often only when installing a replacement skylight that the damage caused by the original is noticed. The moisture damage caused to a roof is often hidden by the shingles and failed flashing around a skylight.
Solar heat control glazing - Manufacturers use various glazing methods to reduce the impact of summer time solar heat gains and winter time heat losses. These come in the form of heat-absorbing tints double and tripled paned skylights and low-emissivity coatings. Slope When your window professional installs your skylight one of the factors they will take into consideration is the slope. The slope or tilt of the skylight affects the amount of solar heat gain. A low slope on your skylight admits more solar heat in the summer and less in the winter which is the opposite of the effect you are trying to achieve As a rule of thumb you want to achieve a slope equal to your geographical latitude plus 5 to 15 degrees.