Skylight / July 12, 2018 / Odo Vaillancour
You will need to position and mark the opening on the ceiling after the skylight is installed. Take into consideration the size of the room and the amount of light you wish to bring in and select the size and position of the hole accordingly. Once the skylight is installed and the ceiling hole is cut its then a matter of connecting the two with the shaft which is typically constructed from 2x4 or 2x6 lumber. The angles involved typically require some tricky framing and is probably best left to an experienced carpenter. After the framing is completed the inside of the shaft is covered with wood or drywall and the attic side is insulated to minimize heat loss.
The air near the ceiling is automatically cooled when fresh air flows in from outside. These roof skylights are so designed that they open and close a little to let in the fresh air. The glass tilts at about 45 degrees. There is a small handle to manually open the venting roof skylight. You crank the handle slightly to open or close or adjust the angle and position of the glass. The venting roof skylights are located in the ceiling of the house and are hard to reach so there is an extension to the handle. Otherwise every time you want to open or shut the venting roof skylight you will need a ladder or a high stool. Nowadays electronically operated venting skylights are also becoming very popular.
Another modern option is to have a replacement skylight with double panes of glass with a layer of argon gas infused in between the panes. New features and options make getting a replacement skylight a more viable option than just shingling over the old one. Remote controls make it possible to open and close a skylight on a whim rather than having to clamber about on ladders. Some skylights can also come with rain sensors so they will close the moment they feel raindrops or too much moisture. These options allow the skylight to vent the house while also protecting it against damage.