Skylight / July 11, 2018 / Nicolas Charlebois
You will need to position and mark the opening on the ceiling after the skylight is installed. Take into consideration the size of the room and the amount of light you wish to bring in and select the size and position of the hole accordingly. Once the skylight is installed and the ceiling hole is cut its then a matter of connecting the two with the shaft which is typically constructed from 2x4 or 2x6 lumber. The angles involved typically require some tricky framing and is probably best left to an experienced carpenter. After the framing is completed the inside of the shaft is covered with wood or drywall and the attic side is insulated to minimize heat loss.
It will also make all the difference for a skylight that doesnt have newer methods for moving condensation away from the window. It is possible that some skylights are suffering manufacturer related defects. Most worthy manufacturers of skylights or replacements will guarantee their product. A new and complete skylight will be sent and installed hopefully at no cost. It will require the same installation techniques as applied with the first but will obviously be better all around. It is often only when installing a replacement skylight that the damage caused by the original is noticed. The moisture damage caused to a roof is often hidden by the shingles and failed flashing around a skylight.
Your ventilating skylight can be operated by one of three ways: Manual skylight controls - These are opened by your use of an extended rod to manually crank the skylight open. These are designed for ceilings of less than 15 feet. Electronic skylight controls - A simpler model of this type of control is wired to a wall mounted switch which opens and closes the skylight. More complex models are controlled by a special wall console of a wireless remote control. Automatic operating controls - With this type of control integrated heat sensors trigger the skylight to open when the interior heat reaches a preset temperature. Exterior sensors automatically close the unit when they sense moisture.