Skylight / July 14, 2018 / Onfroi Berger
The acrylic dome is typically mounted in an aluminum frame which is in turn mounted on a box called a "curb." Once the hole is cut in the roof to the manufacturers specifications the curb is typically constructed on-site to raise the skylight above the level of the roof sheathing. Site-built or factory-supplied flashings are used to seal the roofing around the curb. Domed skylights are available in clear smoked bronze or other tints. Some domed plastic skylights are flush mounted which means that the lens piece and flashing piece are both made of plastic and then placed on the roof without a curb. The problem with this type is that they are loud and very susceptible to leakage.
The structure of the house is another deciding factor. If there are beams pillars or pipes in the way the skylight on the roof may not get the right amount of visibility. Making structural changes is not an affordable option in most cases. So it is better to evaluate the room before you place skylights on the roof. In most cases skylights should be built into the house at the time of drawing the design of the house. In case skylights are introduced at a later point of time care must be taken to ensure that they are placed correctly and installed properly. Skylights are overhead windows often in a roof that allow sunlight to filter inside any enclosed area; they are a great natural light option to artificial lighting solutions during the daytime.
If the room you intend to illuminate with the skylight has an open ceiling with no attic space above you can install the skylight without needing to construct a light shaft. This is by far the simplest installation and it offers the maximum amount of light and a view of the sky. For ceilings with an attic space above a light shaft must be constructed that connects the skylight to the room. Skylight shafts take one of three forms: Straight in which the shaft drops vertically from the roof to the ceiling and is the same dimension as the skylight itself. This type is the easiest to construct but because of its offset angle relative to the skylight offers the least amount of light.